Some suggestions for the use of the automatic Slitter the automatic Slitter is a kind of mechanical equipment that cuts wide paper or film into several narrow materials. The slitter rewinder is often used in paper-making machinery and printing and packaging machinery, with the advantages of stable operation, convenient operation, strong adaptability and high output.

Before the automatic Slitter is put into operation, we should first check whether the working positions are adjusted properly. For the parts to be lubricated, we should add lubricating grease in advance to check whether the cutting tool is sharp. Before the equipment is ready for operation, all personnel must be informed to leave the equipment to ensure personal safety before it can be started up for operation; never touch the membrane roll or roll core in operation by hand, so as to avoid personal injury caused by hand roll; never scratch or cut each roll core with a knife or hard object.

When using the automatic Slitter, we should pay attention to ensure that the voltage, current and hydraulic equivalent are correct and stable before starting the machine. After everything is normal, you can run it empty first, check if there is any abnormality, and input the order to be processed into the computer to arrange the order in advance for inspection; after the equipment is put into operation, you should adjust the working status of the equipment in time according to the production situation, to ensure that the slitter indentation is moderate, the slitting is free of burrs, and the trimming positions on both sides are appropriate. Ensure that the paper feeding and discharging of the cross cutting machine is smooth, and the cutting length is accurate. For the cross cutting machine of joint production management, it is also necessary to monitor its operation at all times to prevent paper blocking and defective products.

After the completion of the work, clean the dust and paper scraps on the equipment in time, check the cutter and grinding wheel, drain the water in the oil and water high reservoir and air tank, and check whether there is any abnormality in the operation part. Then, cut off the power according to the operation requirements of the manual, and maintain the computer operating system. In addition, if there is a problem with the automatic Slitter, it is necessary to find a professional for maintenance. Before maintenance, the power switch must be closed to avoid potential safety hazards.