There are always various problems in the practical application of slitter. Some think it is caused by the old machine, but this is only an objective reason, so what are the reasons? The manufacturer of the slitter will tell you the cause of frequent failures.

Generally, new machines are installed and debugged before leaving the factory. After quality inspection, they are packaged and transported separately. There is not only a problem of level and reasonable installation, but also a problem of inspection and correction. This is especially true for old machines. As for the maintenance and use, we don't need to talk about them. We just want to talk about the maintenance quality:

Maintenance is not a simple disassembly, not only to find out the cause of the failure, but also to find other problems attached.

The slitter has a strict time matching relationship, assembly tolerance and adjustment value. The main reason for the accelerated wear and re failure of the machine is to dismantle the slitter in a hurry and adjust it excessively.

For the purchase and processing quality of spare parts, it is not necessary to use the original spare parts for all parts and electrical components. The cost of the original spare parts is high and the procurement cycle is long. Except for special or key spare parts, most parts and electrical components of other parts can be used as substitutes, as long as you know the processing technology and component characteristics of the parts.