Now many places will use the paper Slitter, but in the process of use, there will inevitably be problems, such as the phenomenon of bursting tendons, so how to solve this phenomenon? Let's analyze it together.
1. When we cut the composite film with only two edges of bursting reinforcement, when the kilometer roll receives about 300m, before the bursting reinforcement does not show up, we should adjust the two edges of the winding shaft; when we receive about 700m, we should adjust each other again, so that the finished roll will not have bursting reinforcement. Thus, the loss is reduced and the yield is increased.
2. When we have thousands of rolls of blasted reinforcement in many images, when we are rolling about 300m, before the blasted reinforcement does not show up, we need to replace a roll of film with no problem to continue winding. In this way, the bursting reinforcement can not be displayed, and the tensile and deformation of the film will not be caused, thus improving the yield.
3. When the slitter is reeled in, a small amount of sanitary smooth powder is sprinkled, which can also alleviate the phenomenon of tendon bursting.
4. Generally, the reinforcement blasting only occurs in the extruded products, but seldom in the dry products.